Stamp Caddy
Home / Guides / Measurements

Measurements

A2 card base size — and how to size any card

A2 is the default card size in the US, and the number people ask for is the finished size, not the cut size. Both are below.

The standard sizes

SizeFinished (folded)
A13½ × 4⅞ in (89 × 124 mm)
A24¼ × 5½ in (108 × 140 mm)
A64⅝ × 6¼ in (117 × 159 mm)
A75 × 7 in (127 × 178 mm)
Slimline3½ × 8½ in (89 × 216 mm)
Note card3½ × 5 in (89 × 127 mm)

Cutting an A2 base

An A2 base is 8½ × 5½ in, scored at 4¼ in and folded — finished size 4¼ × 5½ in. From one 8½ × 11 sheet of cardstock you get two A2 bases, with a 1-inch strip left over that is exactly the width of a mat layer.

Metric: cut 216 × 140 mm, score at 108 mm.

Layer mats without a calculator

The usual step-downs are ⅛ in and ¼ in per side. For an A2 card front of 4¼ × 5½:

  • First mat: 4 × 5¼ in (¼ in smaller each way)
  • Second mat: 3¾ × 5 in
  • Third mat: 3½ × 4¾ in

Want a ⅛ in border instead? Subtract ¼ in total: the mat is 4⅛ × 5⅜ in. The rule is simply: subtract twice the border you want, on each dimension.

How to work out any fold

Almost every fun fold is one of two things: an equal fold, or a fold with a deliberate offset.

  • Equal fold (gatefold, tri-fold): take the long side, divide by the number of panels, score at each division. For a gatefold A2 the base is 8½ in long — divide by three for 2⅞ in panels, so score at 2⅞ and 5¾ and fold both edges in.
  • Offset fold (easel, Z-fold): the panels are unequal on purpose. For a standard easel A2 the base is 4¼ × 11 in, scored at 5½ and 8¼ — the 2¾ in front panel makes the easel ledge.

Before scoring anything expensive, cut a base from printer paper and fold it. Paper is honest in a way that arithmetic is not.

Why the caddy cares about card size

Every size above except slimline has a scrap problem: an A2 cut down to a mat leaves a strip, and strips are what end up across the desk. A tray or well inside arm's reach is the difference between a tidy working area and a table covered in offcuts. The 6 × 4 caddy sits in that footprint — the same 6 × 4 as two A2 bases side by side.


The caddies. Three 3D-printed tool caddies for card making — a full-size Crafting Caddy with five pick tool slots, a low-profile Desk Caddy, and a compact 6 × 4 organiser. Printed to order in Trenton, FL.

More guides