Tools
What a pick tool is used for
A pick tool — sometimes sold as a paper piercing tool, a craft pick or a point tool — is a slim handle with a sharp steel tip. It is the cheapest tool on the desk and the one that gets reached for most.
Five jobs it does
- Lifting a die-cut out of the die. The cut edge is too fine for fingertips and thumbnails crease the paper. One push and the piece lifts cleanly.
- Removing the backing sheet from adhesive. Foam tape and glue dot sheets have a backing designed to be pierced, not peeled with a nail.
- Placing small embellishments. A tip can pick up a rhinestone and place it; fingers cannot.
- Pricking holes for piercing patterns — the classic paper-piercing piercing mats and templates still sell for a reason.
- Clearing a die. The little cut-outs that wedge in the die come out with a tip and stay out of the next impression.
Why five slots, not one
Because a pick tool is only useful where you last set it down, and that is never the same place twice. Stampers who do production runs — twenty of the same card — keep two or three within reach so they are not reaching across a project to find the one they already own.
That is why the Crafting Caddy carries five pick tool slots rather than one. It is not a gimmick count; it is the honest count of how many the tool goes missing against.
What to look for
- A grip that does not spin. A pick you cannot control is a pick that scratches cardstock.
- A cap, if it lives on a desk. A bare tip in a tray will find the bottom of a hand eventually.
- Replaceable tips are worth it if you pierce a lot — the tip dulls before the handle wears.
The alternative
Some stampers use a craft needle in a cork, or a large paper clip. Both work, both roll. If the alternative is a needle loose on the desk, spend the four dollars on a proper tool with a fat handle and its own home.